Count Of Functions 112; Trace Points - Change Level - Siemens SIMATIC HMI Series System Manual

6.3.5.8 Count of Functions
Description
Menu command "Count of Functions" provides the number of standard functions and project
functions and lists the functions by name.
Example
===============================================================

Count of Functions 112

FunctionName UTC PathName \\SERVER1\WinCC50_Project_GSLasttest
\library\UTC.Fct
FunctionName WriteNow PathName \\SERVER1\WinCC50_Project_GSLasttest
\library\WriteNow.Fct
===============================================================
6.3.6

Trace Points - Change Level

Description
The levels of certain trace points can be changed with this menu command.
If you expect e.g. only one certain trace point, you can set the respective level high and are
no longer disrupted by a number of other trace points.
You can change the level by double clicking "Actual Level" for the desired trace point, setting
the desired level in the dialog box and leaving the box with "OK".
The original level is set again with a reset.
WinCC: General information and installation
System Manual, 02/2017, A5E40840020-AA
WinCC diagnosis
6.3 ApDiag Menu Commands
185