Clover HDV043 Instruction Manual page 16

Camera Input
The camera connections are the input ports for the video signal(s) used with the DVR. You
may use any video source (75ohm) that outputs via a BNC connector (Twist Lock Type). If
your video source outputs via RCA/Composite video, the proper adapter must be used
when connecting the cable to the camera connection input port(s) of the DVR. Both NTSC
and PAL signals are automatically detected by the DVR and requires no further
configuration.
Figure 5 Camera Connection
Connect the cameras to the Video In ports located on the rear panel of the DVR using the
proper cables and connectors (BNC Twist Lock). The corresponding video channels can be
"looped" out using the "loop out" ports located beneath each video input port. There is no
need for terminators to be installed, each port is self terminated. Both NTSC and PAL
signals are automatically detected by the DVR and requires no further configuration.
16 | P a g e