Table of Contents
Advertisement
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker. Be sure
you have made a correct connection to the projector audio input. See
18
for how the audio input is connected.
Muting the sound
To temporarily turn off the sound,
1.
Press MENU/EXIT and then press
is highlighted.
2.
Press
on the remote control. The Audio Settings page displays.
3.
Highlight Mute and press
Adjusting the sound level
To adjust the sound level,
1.
Repeat steps 1-2 above.
2.
Press
Turning off the Power on/off ring tone
To turn off the ring tone,
1.
Repeat steps 1-2 above.
2.
Press
The only way to change Power on/off ring tone is setting On or Off here. Setting the sound
mute or changing the sound level will not affect the Power on/off ring tone.
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
•
Menu Display Time in the SYSTEM SETUP: Advanced > Menu Settings menu sets the
length of time the OSD will remain active after your last button press. The time length
ranges from 5 to 30 seconds in 5-second increments. Use
•
Menu Position in the SYSTEM SETUP: Advanced > Menu Settings menu sets the OSD
position in five locations. Use
•
Language in the SYSTEM SETUP: Basic menu sets your familiar language for the On-
Screen (OSD) Menus. Use
•
Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be
displayed during projector start-up. Use
44
Operation
to highlight Audio Settings and press Mode/enter on the projector or ENTER
/
to highlight Volume and press
to highlight Power on/off ring tone and press
/
/
until the SYSTEM SETUP: Advanced menu
to select On.
/
to select a desired sound level.
/
to select a preferred position.
to select your language.
/
to select a screen.
"Connection" on page
/
to select Off.
/
to select a suitable time.
Advertisement
Table of Contents
