Connection; Connecting A Computer Or Monitor - BenQ MP723 User Manual

Benq digital projector user manual
Table of Contents

Advertisement

Connection

When connecting a signal source to the projector, be sure to:
1.
Turn all equipment off before making any connections.
2.
Use the correct signal cables for each source.
3.
Ensure the cables are firmly inserted.
In the connections shown below, some cables may not be included with the projector (see
"Shipping contents" on page

Connecting a computer or monitor

Connecting a computer
The projector provides a VGA and DVI input sockets that allow you to connect it to both
IBM® compatibles and Macintosh® computers. A Mac adapter (an optional accessory) is
needed if you are connecting legacy version Macintosh computers.
Additionally, you can also connect the projector to a computer via the USB cable so you can
perform paging operations of the application on the PC or notebook.
To connect the projector to a notebook or desktop computer (either through a
VGA cable or VGA to DVI-A cable):
With a VGA cable:
1.
Take the supplied VGA cable and
connect one end to the D-Sub
output socket of the computer.
2.
Connect the other end of the VGA
cable to the D-SUB/COMP. IN
signal input socket on the projector.
3.
If you wish to use the remote paging function, take a USB cable and connect the
larger end to the USB port of the computer, and the smaller end to the USB socket
on the projector. See
4.
If you wish to make use of the projector (mixed mono) speaker in your
presentations, take a suitable audio cable and connect one end of the cable to the
audio output socket of the computer, and the other end to the AUDIO socket of
the projector.
Once connected, the audio can be controlled by the projector On-Screen Display
(OSD) menus. See
18
Connection
8). They are commercially available from electronics stores.
1.
2.
"Remote paging operations" on page 40
"Audio Settings" on page 51
With a VGA to DVI-A cable:
Take a VGA to DVI-A cable and
connect the VGA end to the D-Sub
output socket of the computer.
Connect the DVI end of the VGA to
DVI-A cable to the DVI signal input
socket on the projector.
for details.
for details.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mp722 - xga dlp projector

Table of Contents