Related Manuals for BenQ MP610
Summary of Contents for BenQ MP610
- Page 1 MP610 / MP720 / MP770 Ceiling Mounting Guide Welcome...
-
Page 2: Table Of Contents
Copyright Copyright 2005 by BenQ Corporation. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of this company. -
Page 3: Packing Parts List
Packing Parts List CEILING ADAPTER U-PLATE TUBE PIPE PIPE-BASE H – ADJUST ADAPTER PROJECTOR ADAPTER V – ADJUST BOLT NUT x 7 WASHER x 1 M4 SCREW x 10 BOLT x 6 (TUBE BOLT x 2, L – ADJUST BOLT x 2, PIPE BOLT x 2) Names of Parts U - PLATE CEILING ADAPTER... -
Page 4: Projector Installation And Throw Distance Chart
Projector Installation and Throw Distance Chart Floor Installation for a 4:3 screen Maximum zoom Minimum zoom Screen Center of lens Vertical Offset Projection distance Distance from Screen in mm Vertical Offset in mm Feet Inches Min length Average Max length (with max. -
Page 5: Installing A Projector With The Ceiling Bracket
Installing a Projector with The Ceiling Bracket Overview Diagram of completed installation Ceiling Mount Device Installation Procedure Insert the U-PLATE into the CEILING ADAPTER, and tighten two M4 screws (from the bottom) into the STEP A screw holes. Then attach the top part to the ceiling. U-PLATE CEILING ADAPTER M4 screws... - Page 6 STEP B Install the TUBE and the U-PLATE with 2 sets of bolts & nuts (TUBE BOLT). NUTS x 2 TUBE BOLTS x 2 TUBE STEP C Install the PIPE and the TUBE with 2 sets of bolts & nuts (L-ADJUST BOLT). NUTS x 2 L-ADJUST BOLTS x2 PIPE...
- Page 7 STEP E Combine the H-ADJUST ADAPTER (including the PIPE-BASE) and the PROJECTOR ADAPTER with one V-ADJUST BOLT set (bolt, washer and nut). Then tighten the M4 screws on both sides. WASHER H-ADJUST ADAPTER M4 screw V-ADJUST BOLT Assemble BASE-ASSEMBLY and the ceiling mount device with 2 sets of bolts and nuts (PIPE BOLT STEP F sets).
-
Page 8: Adjusting The Ceiling Bracket
Adjusting the Ceiling Bracket Height Adjustment Make sure to remove the projector first. Loosen the nuts securing to the two L-ADJUST BOLTS. Remove the L-ADJUST BOLTS from the PIPE. Adjust to the correct position for the height of the screen. The height can be adjusted to 218mm or any value in a range between 548mm and 758mm in increments of 30 mm. - Page 9 Horizontal Angle Adjustment Loosen the two sets of screws connecting the PIPE-BASE and the H-ADJUST ADAPTER. Adjust the horizontal angle so that it is correct for the orientation of the screen. Re-tighten the two sets of screws connecting the PIPE-BASE and the H-ADJUST ADAPTER.
-
Page 10: Specifications And Diagrams
Specifications and Diagrams Specifications Adjustment Range Height 218mm, 548mm, 578mm, 608mm, 638mm, 668mm, 698mm, 728mm and 758mm. Horizontal angle –30 to +30 degrees Vertical angle +5 to -15 degrees Weight 3.2 kg Loading 3.5 kg Diagrams Left View Front view Right view 10 Specifications and Diagrams...