Setting Up The Mitel 650 Dect Phone For Measurement - Mitel SIP-DECT Site Survey Kit User Manual

SIP-DECT Site Survey Kit User Guide
Additional setup for RFP SX (with external antennas)

SETTING UP THE MITEL 650 DECT PHONE FOR MEASUREMENT

1. Switch ON the Mitel 650c DECT phone for measurement.
2. Date/Time Edit or Esc.
3. Wait until subscribe.
Troubleshooting during Startup
6
1. Connect the mounting kit for external
antennas on top.
2. Install the antennas ("dipole antennas" or
"directional antennas with BNC connector").
3. Connect the antenna cables to the DECT
base station.
The DECT phone shows the standard measurement mode
display with RFP Number (RPN:) and field strength (dBm:).
The Mitel 650c starts up in non-standard measurement mode
(e.g. due to switch off in other mode).
Switch back to the standard measurement mode via:
Right side key (Service menu).
The right side key is not programmed with "Service menu". The
wrong menu structure may activated by accident.
Set up the correct menu structure via:
Menu -> Settings -> Display -> Menu Structure -> [PIN].