NETGEAR S350 Series User Manual page 217

S350 Series 24-Port (PoE+) and 48-Port Gigabit Ethernet Smart Managed Pro Switches
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select Security > Management Security > RADIUS > Accounting Server Configuration.
6. In the Accounting Server Address field, specify the IP address of the RADIUS accounting
server to add.
7. In the Port field, specify the UDP port number that the server uses to verify the RADIUS
accounting server authentication. The default UDP port number is 1813.
8. From the Secret Configured menu, select Yes to add a RADIUS secret in the next field or
select No to ignore the RADIUS secret.
To configure the RADIUS secret, you must select Yes. After you add the RADIUS
accounting server, this field indicates whether the shared secret for this server was
configured.
9. In the Secret field, type the shared secret to use with the specified accounting server.
10. From the Accounting Mode menu, select Enable to enable the RADIUS accounting mode.
11. Click the Add button.
The server is added to the switch.
12. To reset the accounting server and RADIUS statistics to their default values, click the Clear
Counters button.
The following table describes the RADIUS server statistics displayed on the page.
Table 54. RADIUS accounting server statistics information
Field
Accounting Server Address
Round Trip Time (secs)
Accounting Requests
Accounting Retransmissions
Manage Device Security
Description
The accounting server associated with the statistics.
The time interval, in hundredths of a second, between the most recent
accounting-response and the accounting-request that matched it from this
RADIUS accounting server.
The number of RADIUS accounting-request packets sent not including
retransmissions.
The number of RADIUS accounting-request packets retransmitted to this
RADIUS accounting server.
217 User Manual