Table of Contents
Advertisement
Adjusting Lower Wheel
Only do this procedure if you cannot make the
wheels coplanar with the tracking knob or by
shimming the upper wheel. Make sure the upper
wheel is adjusted as close as possible to being
coplanar with the lower wheel before beginning.
Do this procedure with the blade fully tensioned.
To adjust the lower wheel:
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen the jam nuts on the lower wheel
adjustment hub (see Figure 85).
Adjustment
Top Tilt
Hub
Side
Tilt
Bottom Tilt
Figure 85. Lower wheel adjustment control.
-66-
3.
4.
5.
Side
Tilt
Loosen one tilt adjustment hex bolt, then
tighten the opposing hex bolt approximately
an equal amount.
Check the wheels with the coplanarity gauge,
then adjust the lower wheel at the hub as
needed until it is parallel and coplanar with
the top wheel.
Tighten the jam nuts to lock the tilt adjust-
ment hex bolts in position.
Model G0701 (Mfd. Since 9/17)
Advertisement
Table of Contents
