Table of Contents
Advertisement
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The test run consists of verifying the following:
1.
The motor powers up and runs correctly.
2.
The stop button and key switch safety fea-
tures work correctly.
3.
The guide post elevation motor powers up
and runs correctly.
4.
The foot brake operates correctly.
5.
The upper wheel cover safety switch oper-
ates correctly.
Before starting the bandsaw, make sure you
have performed the preceding assembly
and adjustment instructions, and you have
read through the rest of the manual and
are familiar with the various functions and
safety features on this machine. Failure to
follow this warning could result in serious
personal injury or even death!
To test run the machine:
1.
Make sure you understand the safety instruc-
tions at the beginning of the manual and that
the machine is set up properly.
2.
Make sure all tools and objects used during
setup are cleared away from the machine and
that nothing obstructs the blade movement.
3.
Make sure both wheel covers are closed and
secured.
4.
Connect the machine to the power source.
-22-
5.
Push the OFF button in, then twist it clock-
wise so it pops out. When the OFF button
pops out, the switch is reset and ready for
operation (see Figure 21).
OFF Button
Figure 21. Resetting the OFF button.
6.
Verify that the machine is operating correctly
by turning the key switch to "1" (see Figure
22), then pushing the ON button.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— Investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
Guide Post
Elevation Control
Key Switch
ON Button
OFF Button
Figure 22. Control panel.
Model G0701 (Mfd. Since 9/17)
Advertisement
Table of Contents
