Grizzly G0701 Owner's Manual page 29

10. Re-tighten the support bearing shaft adjust-
ment bolt and the rotation adjustment bolts to
secure the bearings in place.
11. Properly adjust the guide bearings (refer to
Adjusting Blade Guide Bearings beginning
on Page 28 for detailed instructions).
Lower Blade Bearing
1. Make sure the blade is properly tensioned
(Page 24) and tracking correctly (Page 19).
2. DISCONNECT MACHINE FROM POWER!
3. Open both wheel covers, then familiarize
yourself with the lower blade bearing controls
shown in Figures 29–31.
Figure 29. Lower support bearing controls.
Rotation
Adjustment Bolt
Figure 30. Front lower blade guide controls.
Model G0701 (Mfd. Since 9/17)
Support Bearing
Shaft Adjustment Bolt
Support Bearing
Knurled Knob
Guide Block
Cap Screws
Figure 31. Rear lower blade guide controls.
4.
To adjust the lower blade bearings, follow
the same procedure used for the upper blade
bearings beginning on the previous page.
5.
Close and secure the lower and upper wheel
covers.
Lateral Rod
Adjustment Bolt
-27-