Table of Contents
Advertisement
Table Tilt Rack and Pinion Assembly
Lubrication Type ........ GL2 Grease or Equivalent
Amount .................................................Thin Coat
Frequency .......................................... As Needed
To lubricate the table tilt rack and pinion
assembly:
1.
DISCONNECT MACHINE FROM POWER!
2.
With the table perpendicular to the blade, and
using a rag and mineral spirits, wipe off all
existing grease and sawdust buildup from the
rack.
3.
Move the table up to its maximum 45˚ angle
and wipe off all existing grease and sawdust
buildup from the rack (see Figure 65).
Figure 65. Lubricating table tilt rack and pinion
assembly.
4.
Apply a thin coat of multi-purpose GL2 grease
to the rack.
5.
Move the table up and down several times
to distribute the grease, then wipe off any
excess grease.
-50-
Trunnion
Lubrication Type ........ GL2 Grease or Equivalent
Amount .................................................Thin Coat
Frequency .......................................... As Needed
To lubricate the trunnion:
1.
DISCONNECT MACHINE FROM POWER!
2.
Move the table up until it reaches its maxi-
mum 45˚ angle, then use a rag and mineral
spirits to wipe off all excess grease and saw-
dust from the trunnion.
3.
Apply a thin coat of multi-purpose GL2
grease to the outside surfaces of the trunnion
(see Figure 66).
Figure 66. Trunnion lubrication location.
4.
Move the table down and then back up to dis-
tribute the grease, then wipe off any excess
grease from the trunnion.
Model G0701 (Mfd. Since 9/17)
Advertisement
Table of Contents
