Table of Contents
Advertisement
7.
Press the OFF button to stop the machine.
8.
WITHOUT resetting the OFF button, press
the ON button. The machine should not
start.
—If the machine does not start, the OFF but-
ton safety feature is working correctly.
—If the machine does start (with the stop
button pushed in), immediately disconnect
the machine from power. The OFF button
safety feature is not working correctly. This
safety feature must work properly before
proceeding with regular operations. Call
Tech Support for help.
9.
Reset the OFF button, turn the key switch to
"0", then press the ON button. The machine
should not start.
—If the machine does not start, the key
switch safety feature is working correctly.
—If the machine does start (with the key
switch turned to "0"), immediately press the
OFF button and disconnect the machine
from power. The key switch safety feature
is not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
10. Turn the key switch back to "1", then use
the guide post elevation control to raise and
lower the guide post (see Figure 22).
Note: When the foot brake is used, a "kill"
switch stops the flow of power to the machine.
It is the steady pressure on the foot brake
that quickly brings the blade to a full stop.
Model G0701 (Mfd. Since 9/17)
11. Start the machine, then apply steady pres-
sure to the foot brake.
—If the machine turns OFF and the blade
comes to a rapid stop, the foot brake sys-
tem is working properly.
—If the machine does NOT turn OFF, the
foot brake system is not working correctly.
Immediately press the OFF button and
disconnect the machine from power. This
safety feature must work properly before
proceeding with regular operations. Call
Tech Support for help.
12. Press the OFF button, wait for the blade
to come to a complete stop, then open the
upper wheel cover approximately 1" to acti-
vate the safety switch.
Note: This safety switch is designed to inter-
rupt power to the motors when the door is
open.
13. While standing to the left of the machine and
away from the open wheel cover, reset the
OFF button and press the ON button. The
machine should NOT start.
—If the machine does not start, the upper
wheel cover safety switch feature is work-
ing correctly. The Test Run is complete.
—If the machine does start, immediately
press the OFF button and disconnect the
machine from power. The upper wheel
cover safety switch is not working correctly.
This safety feature must work properly
before proceeding with regular operations.
Call Tech Support for help.
-23-
Advertisement
Table of Contents
