Table of Contents
Advertisement
Using terminal commands
SDA
A
VAILABLE FOR
D
Sets/returns the maximum delay for waiting awake (i.e. out of sleep mode) for a
ESCRIPTION
service request of an SDI-12 sensor. This parameter is set to 30 seconds by
default. A larger value may lead to higher power consumption. This should be used
in cases where an SDI-12 sensor needs large time values to return a sensor result.
If you have such sensors and still want to use them, you need to change this
parameter, but please be aware that the RTU's power consumption will be higher.
P
Maximum wake time in seconds (1 to 999).
ARAMETERS
R
The current value (in seconds).
ETURNS
R
SET/GET.
EMARKS
R
No.
EMOTE
E
SDA
XAMPLE
29000 SDA 30 0
#
SDA 50
29000 SDA 0
#
FPC
AVAILABLE FOR
DESCRIPTION:
This command allows the use of sensors that generate pulses with frequencies
between 0.5Hz and 30Hz.
PARAMETERS:
0: let processor enter power save mode and thus not catch "fast" pulses.
1: enable RTU to count "fast" pulses.
NONE: display current setting.
RETURNS:
The current setting, or the command's success or error code.
REMARKS:
GET/SET, starting from RTU firmware version 2.2.0.
REMOTE:
No.
EXAMPLE:
FPC
193 FPC 0 0
#
FPC 1
193 FPC 0
#
FPC
193 FPC 1 0
#
GSMPIN
A
VAILABLE FOR
D
Allows entering the PIN code for activating the SIM card.
ESCRIPTION
P
The PIN code.
ARAMETERS
R
Result: success or error (error if the wrong PIN code was entered).
ETURNS
48
A731
A732
A733
A731
A732
A733
A731
A732
A733
A733GSM
A733GSM
A733GSM
Advertisement
Table of Contents
