Table of Contents
Advertisement
Using terminal commands
When any non-default routing of analog inputs was active when a data frame was
sampled and saved, this is indicated in the data frame's digibyte in bit number 4
(value 16).
R
Yes.
EMOTE
E
Show which analog input is routed to which position in the data frame:
XAMPLE
ANRT
26151 ANRT 0 1 2 3 4 5 6 7 8 9 10 11 0
#
(This example shows the default output of the ANRT command.)
Route the internal temperature sensor value (16) to the position of analog 0 in the
data frame:
ANRT 0 16
26151 ANRT 0
#
C
New analog routings will not take effect immediately, but after the current data slot
AUTION
is saved by the device.
Note:
The last digit in the command reply is the status code (in this case 0, which means:
successful completion of the command).
DATA
A
VAILABLE FOR
D
Returns data stored for a certain device.
ESCRIPTION
P
The ID of the device for which the data is requested and the date/time (in the
ARAMETER
standard format) the data was stored. If missing, it refers to the data of the local
device.
R
A data block.
ETURNS
R
GET only. If the date/time parameter is not included, the latest data is returned. If
EMARKS
the date/time parameter is included, the date and time closest to, but later than, the
given date/time is returned.
R
Yes, for a GET, but only one frame at a time. The A733 can issue the command
EMOTE
only for itself, locally.
E
DATA 9193 1/3/2000 12:12:12
XAMPLE
9193 DATA b1 b2 b3 ... bn 0
#
The data block returned typically contains a number of data frames (telegrams).
The structure of a block is as follows:
The data block returned typically contains a number of data frames (telegrams).
The structure of a block is as follows:
dd mm yyyy hh mm ss si ft d1 d2 ... dn dd mm yyyy ... dn cs
where:
36
17 the value from the RTU's internal battery voltage sensor (raw
values are in the range of 0 to 4095, which describe voltage
levels from 0 to 20 Volts)
A731
A732
A733
A733GSM
Advertisement
Table of Contents
