Configuring An A73X Rtu In The Addvantage Software; Maintaining And Servicing The Rtu; The Rtu Battery - Adcon A73 addWAVE Series User Manual

Rtus
Table of Contents

Advertisement

Configuring an A73x RTU in the addVANTAGE software

Modem in GPRS network: 3 seconds off, half a second on with short blinks in the
off periods.
TCP connection to Gateway established: Blinking in a half-second-on, half-second-
off rhythm.
2.6 Configuring an A73x RTU in the addVANTAGE
software
To configure the A73x RTU with an A840 Telemetry Gateway and the
addVANTAGE 4 Pro software, check the Base Station, Telemetry Gateway A840
and Wireless Mode A440 User Guide.

2.7 Maintaining and servicing the RTU

The A733 unit needs virtually no maintenance. It is waterproof and designed to
withstand harsh environmental conditions (-30 to +70 °C, or -22 to 158 °F), high
RH values, water, and other non-corrosive liquids. It conforms to the European
protection class IP65. These standards also apply to the connectors, as long as
they are mated or capped. Don't let unmated/uncapped connectors on either the
A73x RTU or the sensors be exposed to the environment for extended periods of
time. When used in coastal areas with high salt content in the air, use an extra
protective case to avoid corrosion. Avoid spraying agrochemicals on your RTU, as
they might form very aggressive compounds.

2.7.1 The RTU battery

The internal battery supplies 6.2 volts and consists of either a NiCd (radio RTUs) or
a NiMH (GSM/GPRS) battery pack. The internal electronics manage the battery
charging/discharging process, ensuring it a long life. This approach, coupled with a
remarkably low average consumption (6 mW for the standard RTU and 15 mW for
the GSM RTU), allows an A73x RTU to operate at least two weeks on a fully
charged battery, with the following conditions:
Table 1 shows the A73x device's expected operation time on a fully charged
battery under various conditions. The sensor consumption totals 100 mA.
Radio Activity
20
The channel has moderate radio activity, with requests every 15 minutes.
Total consumption of attached sensors is 100 mA.
The sensors are sampled once every minute and an averaged slot is
stored in the internal memory every 15 minutes.
Sensor Sampling
Average
Estimated
Consumption (mA)
Operation (days)

Advertisement

Table of Contents
loading

This manual is also suitable for:

A733A731A733gsmA732

Table of Contents