Table of Contents
Advertisement
Installing the RTU
2.2 Installing the RTU
The following restrictions apply:
Note:
The above does not apply to the A733GSM/GPRS RTU. In principle there is no
distance limit for this type of device as long as your cellular provider covers the
area where it is installed.
Note:
For technical reasons, Adcon cannot provide adapters for the RJ-12 connector to
the A73x devices.
12
Fig. 1:
Fig. 2:
•
In general, the typical "line-of sight" distance the RTU can communicate is
10 km (6 miles). This is valid if both the RTU and its partner device are
mounted on a 3 m mast (9 ft.); the results may vary under different
conditions, and you can sometimes achieve greater distances.
•
As with all wireless communication devices, the higher the transmitter is,
the better the communication will be.
•
All A73x devices accept the standard Adcon sensors (A731 excluded),
which are different from the A730MD series in that they provide IP65 class
protection. All Adcon sensors are delivered by default with this new type of
connector. An adapter cable is optionally available to connect current
sensors to the RJ-12 ports of the A730MD stations.
addWAVE RTU (top)
addWAVE RTU (bottom)
Advertisement
Table of Contents
