Approvals - Siemens SCALANCE X-400 Operating Instructions Manual

Approvals

The SIMATIC NET products described in these Operating Instructions have the approvals
listed below.
Note
Issued approvals on the type plate of the device
The specified approvals apply only when the corresponding mark is printed on the product.
You can check which of the following approvals have been granted for your product by the
markings on the type plate.
Machinery directive
The product remains a component in compliance with Article 4 (2) of the EC Machinery
Directive 89/392/EEC.
According to the machinery directive, we are obliged to point out that the product described
is intended solely for installation in a machine.
Before the final product can be put into operation, it must be tested to ensure that it conforms
with the directive 89/392/EEC.
Note for the manufacturers of machines
This product is not a machine in the sense of the EC Machinery Directive. There is therefore
no declaration of conformity relating to the EC Machinery Directive 89/392/EEC for this
product.
EC directives
SIMATIC NET products meet the requirements and aims of the following EC directives.
EMC directive (electromagnetic compatibility)
The SIMATIC NET products described in these operating instructions meet the requirements
of EC directive 2004/108/EC "Electromagnetic Compatibility" for the following areas of
application:
Field of application
Industry
SCALANCE X-400
Operating Instructions, 06/2015, C79000-G8976-C186-12
Emission
EN 61000-6-4 : 2007
Requirements
Immunity to interference
EN 61000-6-2 : 2005
7
133