Table of Contents
Advertisement
OPERATION
1
Connect the plug to the mains socket and switch on.
2
Hold the sander firmly with both hands
Operating The Trigger Switch
Use the trigger switch as follows:
1
Squeeze the trigger, the belt sander will
start.
2
Release the trigger to stop the belt
sander.
3
If continuous operation is required,
squeeze the trigger, and depress the
lock-on button and release the trigger.
4
To stop the belt sander, squeeze the
trigger to release the lock-on button,
then release the trigger.
Using The Sander
a) Make sure that there are no nails or other objects in the area to be sanded.
b) Let the sander reach full speed before applying it to the work surface.
c) Do not apply pressure to the sander during use. The weight of the sander alone is
sufficient for normal use
d) Move the sander evenly over the work area. Do not allow the sander to stay in
one place for too long, this will give an uneven finish.
e) Replace worn sanding belts. The performance of your sander is dependant on
the quality of the sanding belts being used.
f)
Remove the sander from the work area before releasing the trigger, (wait until the
belt has stopped moving before putting the sander down).
Sanding Hints
•
Always use both hands to hold the sander and clamp the workpiece for added
stability and safety.
•
When sanding wood, always sand in the direction of the grain,
Trigger
9
Lock-on
button
Advertisement
Table of Contents
