INTRODUCTION Thank you for purchasing this CLARKE electric car polisher. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service.
GENERAL SAFETY RULES WARNING: READ ALL INSTRUCTIONS. FAILURE TO FOLLOW ALL INSTRUCTIONS LISTED BELOW MAY RESULT IN ELECTRIC SHOCK, FIRE AND/ OR SERIOUS INJURY. SAVE THESE INSTRUCTIONS WORK AREA SAFETY 1. Keep work area clean and well lit. Cluttered or dark areas invite accidents. 2.
PERSONAL SAFETY 1. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury.
5. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool's operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. 6.
ELECTRICAL CONNECTIONS WARNING! Read these electrical safety instructions thoroughly before connecting the product to the mains supply. Before switching the product on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate. This product is designed to operate on 230VAC 50Hz.
NOTE: Replacement applicator + polisher packs are available from your Clarke dealer part number 6462109 ADJUSTING THE HANDLES 1. Pull the handle away from the main body as shown.
OPERATION & USE SWITCHING ON/OFF TO SWITCH THE POLISHER ON 1. Slide the switch to the left towards the 'ON' position. • When switching 'on', ensure the polisher is in contact with the surface to be polished and only switch it 'off' after removing it from the surface.
2. Keep the air vents free of foreign matter at all times. 3. If the motor does not operate, it needs to be serviced or replaced by a qualified technician, contact the Clarke international service department. VIBRATION EMMISIONS Employers are advised to refer to the HSE publication “Guide for Employers”.
Page 10
‘a’, to which the tool could vibrate under normal conditions. These values appear in the specification panel below. Model Number CP254 Description Polisher Declared vibration emission value in accordance with EN12096 Measured vibration emission value - a: 7.59 m/s...