Table of Contents
Advertisement
User Mode Programming Flow Chart
NOTES:
User Mode is only displayed when a metered option is chosen under System Type.
Depending on current option settings, some displays cannot be viewed or set.
Entering User Mode:
Hold the Up and Down buttons for 5 seconds.
NOTE:
User Mode cannot be entered on the Lag unit for System 6.
Enter User Mode
1.
— Press and hold the Up and Down buttons for 5 seconds.
Set Feed Water Hardness
2.
— Press the Shift, Up, and Down buttons to move the cursor and change the value of the numbers.
— Press the Extra Cycle button to proceed to the next step.
NOTE: Only displayed when a metered option is chosen under System Type.
Set Regeneration Day Override
3.
— To turn on and set the days, press the Down button.
— Press the Shift, Up, and Down buttons to move the cursor and change the value of the numbers.
— Press the Extra Cycle button to proceed to the next step.
Regeneration Time
4.
— Press the Shift, Up, and Down buttons to move the cursor and change the value of the numbers.
— Press the Extra Cycle button
End of User Programming Mode
5.
Page 20
FEED WATER
HARDNESS:
gpg
REGENERATION DAY
OVERRIDE: OFF
REGENERATION DAY
OVERRIDE:99 DAYS
REGENERATION
TIME:
02:00AM
Advertisement
Table of Contents
