Network/Communication Cables & Connections - Pentair 3200NXT Service Manual

Network/Communication Cables & Connections
Use either a CAT3 or CAT5 Network/Communication cable.
1. Connect the network/communication cable first before programming.
2. The maximum cable lenth between timers is 100 feet.
3. Connect each unit together from one communication port to the next communication port. It does not
matter which one goes to the next one.
The number of network/communication cables needed for setup is one less than the total number of valves.
Two-Unit System:
Three-Unit System:
Four-Unit Systems:
Page 8
3200NXT Circuit Board
One network/communication cable
Two network/communication cables
Three network/communication cables
1 2