Table of Contents
Advertisement
Entering Diagnostic Mode:
1.
Push and release the "D" button.
2.
Press the Extra Cycle button once per
display until all displays are viewed and
Normal Display is resumed.
3.
Push and release the "D" button at anytime
during diagnostic mode and the timer will
exit the mode.
4.
Depending on current valve programming,
certain displays may not be able to be
viewed or set.
NOTE: If a System 6, Unit#1 of "Tank
Remaining" will display "System
Remaining).
Diagnostic Mode Flow Chart
CURRENT FLOW
RATE:
0 gpm
PEAK FLOW RATE:
0 gpm
TOTALIZER:
130 g
LAST TWO REGENS:
0 HOURS
LAST REGEN:
0 HOURS
VOLUME REMAINING
TANK:
0000000 g
VALVE ADDRESS
VERSION: NXT
#2
1.00
Page 21
Advertisement
Table of Contents
