What To Do If; The Take-Up Unit Doesn't Take Up Media; Media Take-Up Is Not Straight - Roland TU2-64 User Manual

5. What to do if...

The Take-up Unit Doesn't Take Up Media.

Are the power cord and AC adapter connected correctly?
Connect securely, so that the connection will not come loose or be incomplete.
Is the AUTO switch set to [OFF]?
Set the AUTO switch to match the direction of take-up.
Is the setting for the AUTO switch at the correct position?
Orient the setting of the AUTO switch to match the direction of take-up for the media.
Is automatic cutoff of the media being performed?
Take-up quits as soon as the media is cut off. On the computer (the software RIP), make the setting so that the printer doesn't
perform automatic cutoff. For more information about the setting for automatic cutoff, refer to the documentation for the
software RIP.
Is the paper tube installed correctly?
Securely insert the paper tube onto the end caps. If the paper tube is not attached correctly, it may spin without traction
and fail to take up the media.
 P. 20, "Assembling and Installing" Procedure
Is the paper tube bent or sagging?
Media cannot be taken up smoothly when the paper tube is bent or sagging.
Are you using the included paper tube?
For the paper tube, use the included item. Using something other than the included item may result in spinning without
traction or other problems that impede media take-up.
 P. 22, "About the Paper Tube"

Media Take-up Is Not Straight.

Is the media loaded correctly?
Remove the media, then redo media loading from the beginning.
3.
-
31