Roland TU2-64 User Manual page 18

3. Assembling and Installing
2.
Secure the assembled take-up unit in place on the printer stand.
Check to make sure the screws on the printer stand are not loose.

Retighten if loose.
 Place the take-up unit on the stand.
Determine where to secure the take-up unit in place.

Secure mounting fixture A in place using bolts with washers.
The mounting location varies according to the printer.
Make sure the take-up unit is completely flush with the stand.
Place so that the control box and frame are pressed against the stand leg and mounting fixture A is pressed against
the caster.
TrueVIS series (VG-640,VG-540)
Attaching method of the VG-640, VG-540, refer to exhibit manual "Change notice for the user's manual contents".
PRO II/PRO II V series, SP-540V
Stand leg
16
Front side of the printer
Place
pressed
against.
Frame
Control box
Bolts with
washers
Mounting
fixture A
Hex wrench (small)
Place
pressed
against.
Stand
leg
Control box
Top
Slot
Bottom
Mounting fixture A
The left and right sides
have no handedness.
Caster
Place
pressed
against.
Mounting fixture A