Roland TU2-64 User Manual page 28

4. Operation

W1200mm
When you begin take-up, take care to ensure that the end of the media does not become rolled or
creased.
This completes loading of the media.
PRO II/PRO II V series, SP series (except SP-540i and 300i)
1.
Pass the media through the printer.


Steadily lighted
Check to make sure the following setting-menu items on the printer are each set to "DIS-

ABLE."
The [PREFEED] setting-menu item

The [FEED FOR DRY] setting-menu item (only on models where this setting is available)

For information on how to check or change setting values, refer to the user's manual for the printer.
26
Press
The screen shown in the figure appears.
Dancer roller
OK
Not
OK
.
Move the dancer roller toward the
rear.
Load roll media onto the printer and put
the printer in the setup state (so that
is illuminated).
For information on how to perform loading, refer
to the user's manual for the printer.
After loading, check the following points.
 The media is loaded straight.
 All areas of the media are taut.
If the media is slack or crooked, cancel the setup
state and reload the media.