Roland TU2-64 User Manual page 26

4. Operation
2.
Fasten the media to the paper tube.
 Make sure the screen shown in the figure is displayed, then use
dia until its leading edge reaches the paper tube. Check to make sure the media is pulled
out straight at this time.
If the media is not straight, redo the loading operation.
You can adjust the length of the media in 10-millimeter steps by pressing
hold down the key. )
LOAD SHEET
TO TAKE-UP
Using adhesive tape, fasten the center and side edges of the media to the paper tube

(fasten a total of three locations).
Secure the center of the media in place while keeping the media stretched taut to keep
it free of slack.
While pulling the media from the center outward, fasten the left and right edges.
Take-up with outward curl
Take-up with inward curl
24
OK
Paper tube
Adhesive tape
Paper tube
Adhesive tape
to pull out the me-
(To pull out media continuously,
Not
OK