Jackson TempStar Series Installation, Operation And Service Manual page 23

INSTALLATION
3
Reinstall the four 1/4-20 bolts that were removed in step 1 with a 7/16 wrench. They insert into the machine on the
right and left corners.
4
Connect pressure gauge with a 9/16 wrench. Connect the two hoses using an adustable wrench. The hoses are cut-
to-length and will only reach their intended connection point.
A. Connect the Gauge
C. PRV Inlet from Coil
5
Before moving to the next step, tidy up the hoses by sliding them under the clamps. You might need to loosen the nut
to accomplish this.
07610-002-23-32-AC
VENTLESS MOUNTING INSTRUCTIONS
B. Final Rinse Inlet
D. Booster Outlet
15