Settings In The Ladder Program Edit Screen; Settings In The Parameter Settings Screen - Omron ZEN Operation Manual

Using Timers (T) and Holding Timers (#)
Holding Timer Operation (#0 to #7)
Timer type
X ON delay
timer only
Note
3-6-1

Settings in the Ladder Program Edit Screen

Timer triggers, reset outputs, and timer inputs are drawn on the Ladder
Program Edit Screen. Settings are made on the Parameter Settings
Screen.
Trigger input
Reset input
Timer address
Timer address Timers: T0 to Tf (16 timers)/ Holding Timers: #0 to #7 (8 timers)
Trigger input T (TRG) Controls the timer trigger output. Triggers the timer when the trigger
Reset input R (RES) Controls the timer reset output. When the reset input turns ON, the
Timer bit Turns ON according to the timer type.
Note
3-6-2

Settings in the Parameter Settings Screen

Timer address
68
Turns ON
Trigger input
after a set
Reset input
interval after
Setting
Present
the trigger
value
input has
Timer bit
turned ON.
Only #0 to #3 (4 points) are supported by pre-V1 CPU Units.
Timer bit
input turns ON.
present value is reset to 0 and the timer bit turns OFF. Trigger inputs
are not accepted while the reset input is ON.
Only T0 to T7 (8 points) and #0 to #3 (4 points) are supported by
pre-V1 CPU Units.
Timer type
Operation
0
Trigger specification
Timer number
Timer trigger output
Timer reset output
Reset specification
Time up output
Time units (s)
Monitor enabled/disabled
Set value
Section 3-6
Main
applications
When opera-
tion is to be
continued
even during
momentary
power inter-
ruptions and
longer power
interruptions.