Omron ZEN Operation Manual page 57

Wiring
Connectable Wires
One-line connec-
tion
Two-line connec-
tion
34
Floor Ducts
Leave at least 200 mm between the wiring and the top of the duct, as
shown in the following diagram.
Control cables and
I/O lines power lines
Conduits
Separate the ZEN I/O lines, power and control lines, and power
cables, as shown in the following diagram.
Control cables and
power lines
I/O lines
Do not run ZEN I/O lines in the same duct or conduit as power lines.
• A terminal block designed for solid wires is used. Use solid wires
when wiring.
Solid wires
2
0.2 to 2.5 mm
2
0.2 to 0.75 mm
• Strip the sheath back 6.5 mm.
6.5 mm
Power cables
Power cables
Stranded wires
2
0.2 to 2.5 mm
(Equivalent to AWG 24 to 14.)
2
0.2 to 0.75 mm
(Equivalent to AWG 24 to 19)
Section 2-2
Metal plate (iron)
200 mm min.
Straight terminals
0.25 to 2.5 mm
0.25 to 0.75 mm
2
2