Omron ZEN Operation Manual page 79

Creating Ladder Programs
3-3-3-1 Writing an Input for I0
3-3-3-2 Writing Serial Input I1
Writing Inputs
Input Symbol Configuration
56
Press the OK Button to display the initial
write setting (N.O input I0) and move the
flashing cursor to the bit type I position. Use
the Up/Down Buttons to select the bit type.
Use the Right Button to move the flashing
cursor to the 0 position and then use the Up/
Down Buttons to select the bit address.
Press the OK Button twice to complete the
write operation for input I0. The highlighted
cursor will move the next input position.
Press the OK Button to display the N.O. input
and input I0 again.
Press the ALT Button to switch to a N.C.
input.
(Press the ALT Button again to switch back
to a N.O. input.)
Use the Right Button to move the flashing
cursor to the bit address position and use the
Up Button to change the bit address to 1.
Press the OK Button to move the highlighted
cursor to the next input position. A connec-
tion will automatically be created between
input I0 and the next input.
Bit type
Bit number
Input symbols (
N.C. input.)
Section 3-3
N.O. input;