Local Installation
3.4 Connect the Switch to the Server Interface Module using the
included Belkin CAT5e Patch Cable or other CAT5 cable. (Refer to
diagram below.)
3.5 Power up your server.
3.6 Repeat steps 3.1 through 3.5 for each additional Sun server you
wish to connect.
Note: When a USB or Sun Server Interface Module is connected to a Sun
server, the Server Interface Module emulates the Sun keys using a set of
key combinations called combo keys. Refer to the table on page 67 for a
list of Sun functions supported by the Switch.
�����
���
�����������
�������
������
��������
1
2
3
4
5
6
7
8
9
10
21