Remote Installation; Identifying The Ip Address - Belkin OmniView F1DP108Gea User Manual

Remote Installation

Step 1 Identifying the IP Address
Once your Switch has been connected to your network and is powered up,
a Dynamic Host Configuration Protocol (DHCP) server on your network will
automatically assign the Switch an IP address, gateway address, and
subnet mask.
To identify the IP address on your network, use the MAC address or unique
device number located on the back of the Switch. If no DHCP server is
found on your network, the Switch will boot with the following static IP
address: 192.168.2.155.
If you want to connect more than one Switch to the same network and there is
no DHCP server available, connect each Switch to your network one at a time
and change the static IP address of each unit before connecting the next unit.
Note: If a DHCP server later becomes available on your network, the
Switch will take a new IP address from the DHCP server. To keep the
original static IP address, you will need to disable DHCP (see page 32).
28