Starting Warm Engine; Stopping Engine - Shindaiwa EB633RT Owner's/Operator's Manual

Starting Warm Engine

1. Move throttle lever (A) forward to idle position.
2. Slide stop switch (B) forward to run position.
3. Pull recoil starter handle (E) and engine should start. Do
not use choke (C).
NOTE
If engine does not start after 5 pulls, repeat Cold Starting
Procedure.

Stopping Engine

1. Release throttle trigger (C).
2. Move throttle position lever (A) forward to idle position
and allow engine to return to idle before shutting engine
off.
3. Slide stop switch (B) to Stop position.
WARNING
If engine does not stop when switch is moved to STOP position, close choke _ COLD START position - to stall engine.
Have your dealer repair the stop switch before using blower again.
E
C
D
B
A
C
15