Starting Cold Engine - Shindaiwa EB633RT Owner's/Operator's Manual

Mixing Instructions
1. Fill an approved fuel container with half of the required amount
of gasoline.
2. Add the proper amount of 2-stroke oil to gasoline.
3. Close container and shake to mix oil with gasoline.
4. Add remaining gasoline, close fuel container, and remix.
NOTICE
Spilled fuel is a leading cause of hydrocarbon emissions. Some states may require the
use of automatic fuel shut-off containers to reduce fuel spillage.
• Empty the fuel tank prior to storing the unit. Return unused fuel to an approved fuel
storage container.
Storage - Fuel storage laws vary by locality. Contact your local government for the laws
affecting your area. As a precaution, store fuel in an approved, airtight container. Store in a
well-ventilated, unoccupied building, away from sparks and flames.
NOTICE
Stored fuel ages. Do not mix more fuel than you expect to use in 30 days, 90 days when a fuel stabilizer is added.
NOTICE
Stored two-stroke fuel may separate. ALWAYS shake fuel container thoroughly before each use.
NOTICE
Used oil and gasoline, and soiled towels are hazardous waste materials. Disposal laws vary by locality.

Starting Cold Engine

Recoil starter: Use short pulls; only 1/2-2/3 of rope length for
starting. Do not allow the rope to snap back in. Always hold
the unit firmly.
1. Move throttle lever (A) forward to idle position.
2. Slide stop switch (B) forward to run position.
3. Move choke (C) up to "Cold Start" position (
4. Pump purge bulb (D) until fuel is visible and flows freely in
the clear fuel tank return line. Pump bulb an additional 4 or
5 times
5. Pull recoil starter handle (E) until engine fires (5 or 6 pulls
maximum).
6. Move choke (C) down to run position (
restart engine.)
NOTE
If engine does not start after 5 pulls, move choke to "Cold
Start" position and repeat steps 4 & 5.
NOTE
Allow engine to warm up before use.
14
).
). If necessary,
E
C
D