Assembly; Install Blower Pipes - Shindaiwa EB633RT Owner's/Operator's Manual

ASSEMBLY

WARNING
Never perform maintenance or assembly procedures with engine running or serious personal injury may result.

Install Blower Pipes

1. Assemble clamps (A) and (G) onto both ends of flexible
pipe (B).
NOTE
Clamp with cable guide loop (G) fits elbow end of flexible
pipe.
NOTE
A light lubricant may be used to ease assembly of flexible
pipe to blower elbow.
2. Assemble flexible pipe to elbow (D) on blower. Position
clamp with cable guide loop (G) on outside of flexible
pipe and tighten clamp.
NOTE
Hang handle freely from blower to assure throttle cable is
not twisted before installing handle (E).
3. Position cable along the outside of elbow. Loosen knob
(H) on handle (E). Align notches in handle with tabs (F)
and install onto swivel pipe (C) past long ridges in pipe.
4. Assemble swivel pipe into flexible pipe and tighten
clamp (A).
5. Clip throttle cable into throttle cable guide loop.
6. Move handle (E) to desired position. Tighten knob (H)
hand tight.
7. Assemble straight pipe (K) onto swivel pipe, until you
feel light resistance. Do not force connection. Hold
swivel pipe and turn straight pipe clockwise, engaging
positive locking channels, until connection is firm. Do
not force connection.
8. Assemble straight pipe (J) to straight pipe as in step 7.
NOTE
Blower use will eventually loosen pipe connections. Exclu-
sive positive locking system allows pipes to be tightened.
If loosening occurs, remove two straight pipes and install
according to instructions 7 & 8.
G
G
K
C
G
A
B
D
E
H
F
J
11