Starting Cold Engine - Shindaiwa P45214001001 Operator's Manual

EB600RT

Starting Cold Engine

• Recoil starter: Use short pulls - only 1/2- 2/3 of rope length for starting.
Do not allow the rope to snap back in. Always hold the unit firmly.
1. Throttle Lever
Move throttle lever (A) to IDLE
position.
2. Choke
Move choke (B) UP to COLD
START (
3. Purge Bulb
Pump purge bulb (C) until fuel is
visible. Pump bulb an additional
4 or 5 times.
4. Recoil Starter
Pull recoil starter handle (D) until engine fires, or a maximum of 5 pulls
5. Choke
After engine fires (or 5 pulls),
move choke lever back to RUN
( ) position, then pull starter
handle/rope until engine starts
and runs. Allow unit to warm up
at idle for several minutes.
Note: If engine does not start
with choke in "RUN"
position after 5 pulls,
move choke to COLD
START (
repeat steps 3- 5.
6. Throttle Lever
Allow engine to warm up for several minutes before use.
7. Throttle Lever
After engine warm-up, squeeze throttle trigger, then move throttle lever to
set desired operating speed.
X7505200806
© 11/19 ECHO Incorporated
) position.
) position, and
B
C
D
OPERATION
A
23