9.18 Assembling the control unit
1
Connect the connector from the motor to the con-
trol unit. Connect connector (D) to the control unit
for the keypad, fan and main switch. Make sure the
connector is plugged firmly into the control unit.
•
Make sure that it snaps into place.
•
Press the silicone gasket in place with your
fingers and make sure it fits tightly all around.
•
Snap on the bracket holder.
NOTE! Do not use the bracket holder to
press the silicone gasket in place.
2
Place all the control unit components in the battery
housing.
Take care to return all the cables to their correct
positions to avoid pinching.
Fasten screws (2x) to the control unit (G) and
screws (2x) to the battery contact (H).
Tightening torque 1 Nm.
3
Assemble the battery housing as described in
"6 Basic dismantle/assembly" on page 16
D
S/N: -20180400173
D
S/N: 20180400173-
Repair Instructions
G
H
H
G
English – 45