Husqvarna 536LiHE3 Workshop Manual page 55

Troubleshooting - Appendix
5. Motor and power connectors
Make sure the three motor connectors and the
two power connectors are properly connected to
respective plastic housing.
6. 26-pin wiring cable
Make sure the 26-pin wiring cable is properly as-
sembled, dry and not damaged. See "8.18 Assem-
bling the control cabling" on page 38.
7. Transport mode sensor
Make sure the transport mode sensor is assem-
bled and connected properly. Check the cables for
damages. See "9.2 Dismantling the gear package"
55 – English