Husqvarna 536LiHE3 Workshop Manual page 29

Repair Instructions
4
Assemble the nuts holding the cutting unit.
5
Carefully put together the cutting unit and the shaft.
Make sure the cables are not damaged.
6
Assemble the cover on the gear joint, 5 screws.
7
Assemble the two cable shoes for the transport
mode sensor.
8
Position the lower motor cover.
Assemble the air conductor and the screw holding the
air conductor.
NB! See "9.20 "To disassemble and assemble the air
conductor" on page 48 for a detailed description of
assembling the air conductor.
Refer to SB B1180039A-07 for important information
about the Air Conductor.
9
Assemble the cables to the motor. Press the cable
shoes straight down on the pin.
NB! See "9.21 To connect the motor cables" on page 49
for a detailed description of connecting the motor.
NB! The positioning of the wiring and the wiring colors
are engraved in the air conductor.
10
Assemble the 4 screws that hold the cover.
29 – English