Husqvarna 536LiHE3 Workshop Manual page 6

2 Introduction and Safety Instructions
2.1 General information
This Workshop Manual provides a comprehensive
description of how to troubleshoot, repair and test
the product. A description of different safety steps
that must be taken during repair work is also given.
2.2 Safety
Note! The section dealing with safety must be
read and understood by all those carrying out
repair work or service on the pole hedge trim-
mer.
Warning symbols can be found in this Workshop
Manual and on the product. See "Symbols on the
product" and "Symbols in the Workshop Manual".
A new warning symbol decal must be applied as
soon as possible if a warning symbol on the prod-
uct has been damaged or is missing so that the
greatest level of safety can be maintained when
using the product.
2.3 Target group
This Workshop Manual is written for personnel with
general knowledge about the repair and service of
pole hedge trimmers.
The Workshop Manual must be read and un-
derstood by personnel who will carry out repair
work and service on the pole hedge trimmer. The
Manual is also suitable for use when training new
employees.
2.4 Changes
Any modifications to the product will be gradually
introduced into ongoing production. As these modi-
fications affect service and/or spare parts, specific
service information will be sent out on each occa-
sion. This means that in time this Workshop Manu-
al will become out of date. In order to prevent this,
the Manual should be read together with all service
information concerning the product in question.
2.5 Tools
Special tools are required for some stages. All
service tools are listed in the Workshop Manual.
Usage is made evident in each section.
Always use original Husqvarna:
• Spare parts
• Service tools
• Accessories
Introduction and safety regulations
2.6 Structure
This Workshop Manual can be used in two different
ways:
• For the repair of a particular system on the prod-
uct.
• Dismantling and assembling the entire product.
Repair of a particular system
Proceed as follows when a particular system on
the product is to be repaired:
1. Look up the page for the system in question.
2. Carry out the following steps:
• Dismantling
• Cleaning and inspection
• Assembling
Dismantling and assembling the entire product
Proceed as follows when taking apart and assem-
bling the whole product:
1. Open the chapter "Basic dismantle" and carry
out Dismantling in the order set out in the sec-
tions.
2. Open the chapter "Repair instructions" and carry
out Dismantling in the order set out in the sec-
tions.
3. Carry out Cleaning and inspection in the order
set out in the sections.
4. Carry out Diagnostic troubleshooting if a fault
in the electrical system is suspected.
5. Order or collect all requisite spare parts from the
stores.
6. Carry out Assembly in the order set out in the
sections.
2.7 Numbering
Position references to components in the figures
are designated A, B, etc.
The figures are numbered 1, 2 etc.
The position references and figure numbers restart
in each new section.
English – 6