Assembling The Control Unit - Husqvarna 536LiL Workshop Manual

Repair Instructions

Assembling the control unit

For products with S/N: 2015080001- (536LiL,
536LiLX), 20151000001- (536LiR, 536LiRX).
1
Connect the cables from the motor to the control
unit with (A, gray) at the top, followed by (B, black)
in the middle and (C, red) at the bottom. Connect
connector (D) to the control unit for the keypad,
fan and main switch. Make sure the connector is
plugged firmly into the control unit.
See figure 18b.
2
Place all the control unit components in the battery
housing.
Take care to return all the cables to their correct
positions to avoid pinching.
Fasten screws (2x) to the control unit (G) and
screws (2x) to the battery contact (H).
Tightening torque 1 Nm.
See figure 19b.
3
Assemble the battery housing.
Refer to "Basic dismantle/assembly".
4
Assemble the wear guard under the battery housing.
Refer to "Basic dismantle/assembly".
5
Assemble the operating handle (LiL).
Assemble the handle arm (LiR).
Refer to "Basic dismantle/assembly".
48 –
English
D
Fig 18b
Fig 19b
A
B
C
G
H
H
G