Husqvarna 536LiHE3 Workshop Manual page 43

We recommend dismantling the control unit before
assembling the control cabling, see "8.19 Dismantling
the control unit" on page 46.
For products with S/N: 20180400173- (LiHE3).
1
Connect the connector to the control unit.
• Make sure that it snaps into place.
• Press the silicone gasket in place with your fingers
and make sure it fits tightly all around.
• Snap on the bracket holder.
NOTE! Do not use the bracket holder to press the
silicone gasket in place.
2
Place the bottom section of the cabling and the fan in
the battery housing.
Assemble the fan, making sure it is positioned in the
correct direction.
3
Lay the cabling in place in the control handle. Make
sure that it is positioned outside (A) and inside (B). Put
the overmoulding behind (C) and the loose cables in
front of (C). Push the cabling all the way down.
NB! Make sure that no cables are in a position where
they don't get pinched or damaged when the control
handle is assembled.
4
Assemble the throttle trigger lock and throttle trigger
as described in "8.2 Assembling the throttle trigger
lock and throttle trigger".
5
Lay the cabling in place in the cable tray and assemble
the control handle and battery housing as described
in "6 Basic dismantle/assembly".
C
B
A
Repair Instructions
English – 43