Genie GS-2646 AV Operator's Manual page 17

Second Edition • Second Printing
Crushing Hazard
Keep hands and limbs out of scissors.
Keep hands clear when folding rails.
Do not work under the platform or in the scissor
links without the safety arm in place.
Use common sense and planning when operating
the machine with the controller from the ground.
Maintain safe distances between the operator, the
machine and fixed objects.
Operation on Slopes Hazards
Do not drive the machine on a slope that exceeds
the slope and side slope rating of the machine.
Slope rating applies to machines in the stowed
position.
Model Maximum slope
rating, stowed
GS-2646 AV
GS-2646 AV35
Note: Slope rating is subject to ground conditions
and adequate traction.
Part No. 1274894GT
Maximum side
slope rating,
position stowed position
25% (14°) 25% (14°)
20% (11°) 20% (11°)
GS-2646 AV • GS-2646 AV35
Work Area Safety
Fall Hazards
The guard rail system provides fall protection. If
occupant(s) of the platform are required to wear
personal fall protection equipment (PFPE) due to
job site or employer rules, PFPE and its use shall
be in accordance with the PFPE manufacturer's
instructions and applicable governmental
requirements. Use approved lanyard attachment
point provided.
Keep the platform floor clear of debris.
Do not enter or exit the platform through the rear
gate, unless the machine is in the stowed position.
Follow the procedure on page 8 to exit or enter an
elevated platform through the front gate.
Close the entry gates before operating.
Do not operate the machine unless the guard rails
are properly installed and the entries are secured
for operation.
Operator's Manual
Do not sit, stand, or climb
on the platform guard
rails. Maintain a firm
footing on the platform
floor at all times.
Do not climb down from
the platform when raised.
15