Elsd Maintenance; Cleaning The Elsd Detector - Teledyne ACCQPrep HP125 Installation And Operation Manual

Figure 6-28 Attaching the new tubing
Figure 6-29 Replace the outer band

6.7 ELSD Maintenance

6.7.1 Cleaning the ELSD
Detector
3. Slide the new peristaltic tubing with the thicker tubing
towards the AutoSampler (Figure 6-28).
4. Replace the outer band of the peristaltic pump (Figure
6-29).
Periodic cleaning of the spray chamber will keep the
ACCQPrep operating at maximum performance. Use the
following steps if spray chamber cleaning is recommended.
1. From the run screen select the M
2. In the Peak detection window, select the ELS D
radio button then select D
3. Set the spray chamber temperature to
4. Exit the Edit Method screen and accept the changes, then
allow approximately 5 minutes for the chamber to reach
the set temperature.
ACCQPrep HP125
Section 6 Maintenance
E .
ETHOD DITOR
ETECTOR
.
ETAILS
.
40°C
6-19