Table of Contents
Advertisement
Chapter 2
Figure 2-3: IsoPlane 81 Power and Data Interface Panel
Table 2-2 provides information about the power and data interface ports.
Table 2-2:
User Input/Output
Output Trigger A, B
Power In
Trigger In
USB 3.0
2.3
IsoPlane 81 System Maintenance
2.3.1
Cleaning
Although there is no periodic maintenance that needs to be performed on an IsoPlane
81 spectrometer, users are advised to wipe it down with a clean damp cloth from time
to time. This operation should only be done on the external surfaces and with all covers
secured. In dampening the cloth, use clean water only, and wring out all excess water.
The cloth should only be slightly damp, not wet (i.e., no water should drip off the cloth).
IsoPlane 81 System
Power and Data Interface Panel
Port
General purpose input/output port.
Fully programmable output triggers using the integrated Timing
Generator.
Power input from external power supply provided with the IsoPlane 81
system.
Allows data acquisition and readout to be synchronized with external
events.
Positive or negative edge triggering is programmable.
Control signals and data are transmitted between IsoPlane 81 and host
computer via this port.
WARNING!
Turn off all power to the equipment and secure all covers
before cleaning the unit. Otherwise, damage to the
equipment or injury to you could occur.
Description
13
Advertisement
Table of Contents
