Piece Deflector Assembly - Blodgett 900 Series Installation Manual

OVEN ASSEMBLY
DOUBLE SECTION ASSEMBLY - 1048 AND 1060
1. Fasten 12" (305 mm) legs to lower section.
2. Remove the sheet metal flue cover on bottom of UPPER SECTION FLUE ONLY and save the two screws.
3. Fasten crown angle leg frame to upper sections.
4. Insert double oven flue connector into upper oven section flue until it is flush with the base angle. Temporarily hold in
place with tape.
5. Install upper section on bottom section.
6. Remove tape and slide flue connector into position over the collar of the bottom section. See Figure 4.
7. Fasten flue connector to bottom section with screws from the flue cover.
8. Install drafthood or draft diverter with screws provided.

3 PIECE DEFLECTOR ASSEMBLY

1. Deflectors are shipped in place in the oven. No assembly is required.
2. Remove the shipping clip located in the back center of each deflector before inserting two-piece shelf assembly.
Ultra Rokite Deck
1. Slide one half of the Ultra Rokite shelf through the door opening. Rest the shelf on the deflector and slide to the rear of
the oven until it drops into the shelf support. Slide the shelf to the right.
2. Slide the other half of the Ultra Rokite shelf on top of first shelf to the rear until it is within the shelf support. Slide it all
the way to the left until it drops down into place.
3. Slide both shelf halves inward so the center joint closes.
4. Refer to pre-heating instructions supplied with Ultra Rokite.
NOTE: Because of the weight of the Ultra Rokite shelves, take care to avoid injury to yourself or damage to the shelves
when sliding sections into the oven. Use of 1" x 4" pieces of lumber will help to slide shelves into place.
DECK OVENS
Figure 4
6 INSTALLATION