Initial Settings - Omron NT20M Operation Manual

Initial Settings

Abort:
3-4 Initial Settings
3. Perform the transfer operation from the Support Tool. The screen shown
below will be displayed during the transfer.
Transmit Mode
KB
4. In the event of a disconnected cable or other disruption while the trans-
fer is in progress, the PT screen will go blank and a message telling you
that transfer was not possible will be displayed at the Support Tool. If the
transfer is completed successfully, then at the end of the transfer the PT
screen will go blank and a message telling you that the transfer has
been completed will be displayed at the Support Tool.
5. To return from Transmit Mode to RUN Mode, press the Buzzer Key, Up
Key, and Down Key simultaneously.
Note After completion of the transfer, be sure to change to Maintenance Mode. If
power is turned off or the reset switch is pressed before changing to Mainte-
nance Mode, the data that is transferred will be damaged.
When using the EEPROM as a screen data memory, screens cannot be
transferred screen by screen from the Support Tool to the PT. The screen
data must be transferred in file units after initializing the memory.
When power is turned on, the PT's internal status is initialized to the following
settings.
Item
Character string memory
Numeral memory
Lamp/touch switch status
Key Press Sound
Backlight Off
Display
PT --> Host Shows direction
Host --> PT of data transfer.
Screen Data
System Memory
Memory Tables
Shows type of data.
Mark Data
History Data
Number of bytes transferred (in kilobytes).
Press these three System Keys simulta-
neously to stop the transfer in progress.
Initial value
Screen data memory content
Screen data memory content
OFF
ON (When a battery is installed, the previously set
value is retained.)
10 minutes (When battery is installed, the
previously set value is retained.)
No display or initial screen (At the Support Tool you
can set either no display or initial screen.)
Section 3-4
33