Table of Contents
Advertisement
Section 3 - Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide
you with a username and password. This option is typically used for DSL services. Make sure to remove your PPPoE
software from your computer. The software is no longer needed and will not work through a router
My Internet
Select PPPoE (Username/Password) to obtain IP address
Connection
information automatically from your ISP. Select this option
is:
if your ISP does not give you any IP numbers to use.
Address
Select Static IP if your ISP assigned you the IP address,
Mode:
subnet mask, gateway, and DNS server addresses. In most
cases, users will select Dynamic IP (DHCP).
User Name:
Enter your PPPoE user name.
Password:
Enter your PPPoE password.
Confirm
Retype the PPPoE password entered above.
Password:
Service
Enter the ISP service name (optional).
Name:
IP Address:
Enter the IP address (Static PPPoE only).
MAC
The default MAC address is set to the Internet port's physical
Address:
interface MAC address on the broadband Router. It is not
recommended that you change the default MAC address
unless required by your ISP. You can use the Copy Your
PC's MAC Address button to replace the Internet port's MAC
address with the MAC address of your Ethernet card.
Primary DNS
Enter the primary DNS server address (Static PPPoE only).
Server:
D-Link DIR-604 User Manual
Manual Internet Configuration (PPPoE)
.
43
Advertisement
Table of Contents
