Table of Contents
Advertisement
Section 3 - Configuration
To create a firewall rule, configure the parameters
described below:
Name:
Enter a name for the firewall rule.
Action:
Use the drop-down menu to specify if the Router should
Allow or Deny traffic matching the firewall rule.
Interface:
Use the drop-down menus to select the Source and Dest
(ination) interfaces for the firewall rule. You also may opt
to choose either LAN or WAN for each pair of interfaces.
IP Address:
Use these fields next to each Interface drop-down menu to
specify the IP address ranges for the Source/Destination
interfaces.
The first host in the IP address range should be entered
in the top field and the last host in the IP address range
should be entered in the field beneath for both the Source/
Destination interfaces.
Protocol:
Use the drop-down menu to select the protocol that will be
used for the firewall rule (TCP, UDP, ICMP, or All).
Port Range:
Enter the range of ports that the firewall rule will apply to.
The first port in the port range should be entered in the top
field and the last host in the port range should be entered
in the field beneath.
Schedule:
Use the drop-down menu to select the schedule for the
firewall rule. Click the Add New button to bring up the
Schedule page to configure the new schedule.
D-Link DIR-604 User Manual
Firewall Rules
60
Advertisement
Table of Contents
