Bowflex Max Trainer M7 Service Manual page 92

9. Using a 5mm hex wrench, remove the 4 screws (2 on each side of the
Console Mast) from the Console Assembly.
10. Carefully lift the Console Assembly and expose the Cable Connec-
tions.
Note: do not crimp any of the Console Cables. This step may require two
people.
11. Carefully disconnect the Cables while not allowing them to fall into the
Console Mast.
Note: Do not crimp any of the Console Cables.
12. Using an 8mm hex wrench, remove the indicated hardware from the
Rail Assembly.
Rail Assembly
92